Inquiry

asphalt standard according to astm

City of Regina Standard Construction Specification SECTION

When tested according to A.S.T.M. D7428 (Micro-Deval) the maximum allowable degradation loss should be 25%. 2.1.9 The aggregate must exhibit an affinity for asphalt cement, and meet the Saskatchewan method for Aggregate Stripping Potential, and ASTM D4867

Learn More

STANDARD CONSTRUCTION SPECIFICATIONS FOR ASPHALT

ASTM D-4125 Standard Test Method for Asphalt Content of Bituminous Mixtures by . Page 2 Standard Construction Specifications Division 40 – Asphalt Surfacing Revised 11/08 Nuclear Method ASTM D-4791 Flat and Elongated Particles ... Standard Construction Sp

Learn More

ASTM D7175 - Standard Test Method for Determining the

ASTM D7175 Standard Test Method for Determining the Rheological Properties of Asphalt ... and is not intended as a comprehensive procedure for the full characterization of the viscoelastic properties of asphalt binders. This standard is appropriate for ..

Learn More

Indirect Tensile Test for the Determination of the

Modulus of bituminous mixes determined by the Indirect Tensile Test, conducted according to the EN 12697-26, Annex C and the ASTM D 4123 standards. The testing was performed on high-performance bituminous mixtures, including polymer modified base-binder a

Learn More

ASTM D3381/D3381M-13 - Standard Specification for

The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1 shall apply. For asphalt cements graded by penetration at 25°C [77°F]. See Specification D946. If needed, volume corrections for asphal

Learn More

MATERIAL SPECIFICATION FOR HOT POURED RUBBERIZED ASPHALT

Where requi red by the C ontract A dministrator, the hot poured rubberized asphalt joint sealing compound shall be sampl ed and tested for cone penetrati on, fl ow, resili ence, bond, toughness, and relative density as follows: a) Sample preparation shall

Learn More

ASTM D6373 - Standard Specification for Performance Graded

For asphalt cements graded by viscosity at 60°C see Specification D3381. NOTE 2-AASHTO R 29 provides non-mandatory information for determining the performance grade of an asphalt binder. The values stated in SI units are to be regarded as standard. No oth

Learn More

Reference

What is ASTM specs?

Learn More

SmartPave – Dynamic Shear Rheometer for Asphalt : Quote

For standard asphalt tests according to AASHTO, ASTM, DIN EN, and FGSV. Temperature range: -5 °C to 200 °C. SmartPave 102. SmartPave 102 is ideal for the most demanding measurements. It is used in the research and development of asphalt and bitumen. For s

Learn More

SECTION 321216 - ASPHALT PAVING

A. Hot-Mix Asphalt Paving Terminology: Refer to ASTM D 8 for definitions of terms. B. DOT: Department of Transportation. 1.3 SYSTEM DESCRIPTION A. Provide hot-mix asphalt patching according to materials, workmanship, and other applicable requirements of s

Learn More